D-Link DCS-50 User Manual download pdf (Page 2)

Ⅲ. Fitting instructions for camera

1 Camera mounting platform

2 Terminal block assembly

3 Cable conduits PGB13.5 x 2

4 Captive retainning 1/4” Screws x 3

5 Heater wires, Ground wire

6 Ground wire

Fig.3

(A)

(B)

(C)

(D)

(C)

(H)

(G)

(F)

(E)

(G)

(J)

(I)

1. Unscrew the 3 captive Retaining Screws (C) and remove the Housing Cover (A) from

the Housing Base (B).

2. Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera Platform

(G) from the Housing Base (B).

3. Mount the Camera (H) onto the Platform (G) using the 1/4” UNC Screw (I) supplied, ensuring

that the Insulation Pad (J) is mounted between the Platform and the Camera. Always check

that the Camera is ﬁrmly attached to the Platform.

4. Connect the Camera power cable to the rear Terminal Block (E) through the

ﬁrst Cable Conduit (D) referring to the circuit diagram shown in section IV. for the

terminal designations.

5. Connect the video cable to the Camera through the second Cable Conduit(D).

IMPORTANT NOTE:

ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN

DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER

AGAIN WHEN REASSEMBLING THE HOUSING.

Ⅳ. Wiring diagram

Fig.4 shows the internal wiring diagram of

DCS-50 for the window demister.

When necessary, a spare 6 way terminal

block is provided at the rear of the enclosure

for the camera and lens connections.

Circuit identiﬁed as follows:

TB.1 6 way terminal block

FTB.1 Fused terminal block

FS.1 3 Amp. Fuse

Fig.4 Wiring diagram of DCS-50

TB.1

FTB.1 FS.1

COVER EARTH

CHASSIS EARTH

ENCLOSURE BASE

SPARE

1 2 3 4

User’s Manual 1
Ⅳ. Wiring diagram 2

Comments to this Manuals

No comments

D-Link DCS-50 User Manual Page 2

Comments to this Manuals