D-link DES-1226G User Manual download pdf (Page 8)

Use the screws provided. Then, use the screws provided with the equipment rack to mount the Switch in the rack.

Mount the Switch in the rack.

Connecting Network Cable

The DES-1226G supports 10/100/1000Mbps Gigabit Ethernet. It runs full-/half- duplex transfer mode for

10/100Mbps and full-duplex transfer mode for 1000Mbps. Each port on the DES-1226G supports Auto-MDI/MDI-X.

Auto-MDI/MDI-X is a feature that eliminates the need for worrying about using either a standard or crossover

cable—you can use either one—and allows any port to be an uplink port.

AC Power

The DES-1226G can be used with AC power supply 100~240V AC, 50~60 Hz. The power switch is located at the

rear of the unit adjacent to the AC power connector and the system fan. The Switch’s power supply will adjust to the

local power source automatically and may be turned on without having any or all LAN segment cables connected.

4. Configuration

Through the Web browser you can configure Switch settings such as VLAN, Trunking, QoS… etc.

Using the Switch’s Web Management Utility, you can easily discover all the D-Link Web-Smart Switches in your

network, assign the IP Address, change the password, and upgrade new firmware.

Installing the Web Management Utility

The following gives instructions guiding you through the installations of the Web Management utility.

1. Insert the Utility CD in the CD-Rom Drive.

2. From the Start menu on the Windows desktop, choose Run.

3. In the Run dialog box, type D:\Web Management Utility\setup.exe (D:\ depends where your CD-Rom drive is

located) and click OK.

4. Follow the on-screen instructions to install the utility.

5. Upon completion, go to Program Files -> web_management_utility and execute the Web Management utility.

(Figure 1.)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

No comments

D-link DES-1226G User Manual Page 8