D-Link DGS-1248T - Switch User Manual download pdf (Page 28)

5 Configuration D-Link Web Smart Switch User Manual

System Reboot

Provide a safe way to reboot the system. Click System Reboot to restart the switch.

Figure 38 – Tool Menu > System Reboot

Setup Menu

All configuration options on the switch are accessed through the Setup menu on the left side of the screen.

Click on the setup item that you want to configure. The following sections describe in more detail each of the

features and functions.

Figure 39 –Setup Menu

System > System Settings

The System Setting allows the user to configure the IP address and the basic system information of the

Switch.

IP Information: There are two ways for the switch to attain IP: Static and DHCP (Dynamic Host

Configuration Protocol).

When using static mode, the IP Address, Subnet Mask and Gateway can be manually configured. When

using DHCP mode, the Switch will first look for a DHCP server to provide it with an IP address, network

mask, and default gateway before using the default or previously entered settings. By default the IP setting is

static mode.

System Information: By entering a System Name and System Location, the device can more easily be

recognized through the SmartConsole Utility and in other Web-Smart devices on the LAN.

in the Web-based Management Utility. When the Login Timeout expires, the Web-based Management Utility

requires a re-login before using the Utility again.

Group Interval: The D-Link Web Smart Switch will routinely send report packets to the SmartConsole Utility

in order to maintain the correct data shown. The user can configure the Group Interval to control the time

routine. Zero means disabling Group Interval, and 120~1225 means sending the message according to the

value chosen, the unit is in seconds.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

No comments

D-Link DGS-1248T - Switch User Manual Page 28