D-Link DGE-530T User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
DGE-530T Gigabit Ethernet Adapter Card
1
Introduction
Thank you for choosing the D-Link DGE-530T, the value leader among Gigabit adapters for PCI
Bus personal computers. This introduction gives a general description of the newer networking
technologies found on the DGE-530T.
The DGE-530T provides the bandwidth capability to support high-end servers and workstations.
With Auto-negotiation, this card can run on three different speeds: 10Mbps at half and full
duplex, 100Mbps at half and full duplex, and 1000Mbps at full duplex. When running at
1000Mbps, it provides a network throughput of 2Gbps in full-duplex mode.
The DGE-530T provides IEEE 802.3x Flow Control Enhancements, which are needed for a
network adapter to function with a switch. In full-duplex mode, the MAC implements the PAUSE
control function. This means when a switch is connected in full-duplex mode and it senses that
its buffer will overflow in the near future, the switch will transmit one standard Ethernet packet
that causes the DGE-530T to pause for a period, thus avoiding internal buffer overflow and
packet loss.
The NIC enables simple, scalable network migration, providing the benefits of Gigabit Ethernet
networking with the familiarity of Ethernet.
System Requirements
Before installing the DGE-530T, check your system for the following minimum configuration
requirements.
One of the following slot types:
An open PCI bus master slot, 32-bit or 64-bit, operating at 33 or 66 MHz.
An open PCI-X slot operating at 66, 100 or 133 MHz.
32 MB of System Memory
150 MHz processor, or faster
The latest BIOS for your computer
One of the following types of twisted-pair network cabling:
4 – pair Category 5 or better for 1000Mbps
Category 5 or better for 1000Mbps
Category 3, 5 or better for 10Mbps
Features
Designed for versatility and performance, the DGE-530T Network Adapter provides the following:
Operability in 32-bit, 33 MHz slot servers and workstations
Universal Bus support, 3.3V and 5V
Compliance with IEEE 802.3ab 1000BASE-T Gigabit Ethernet standards, IEEE 802.3u Fast
Ethernet standards.
Plug-and-Play installation
1
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Comments to this Manuals

No comments