Before Your Begin This Quick Installation Guide gives step-by-step instructions for setting up the D -Link DGS1224T Gigabit Smart Switch. The
2 Setup The DGS-1224T Gigabit Smart Switch The setup of the Switch can be performed using the following steps: A. Install the DGS-1224T in a fairly
3 Mount the Switch in the rack Connecting Network Cable The DGS-1224T supports 10/100/1000Mbps Gigabit Ethernet. It runs full/half duplex trans
4 n 1000BASE-T Twisted Pair Ports (Port 1~24) The DGS-1224T is equipped with two Gigabit twisted pair ports that are auto negotiable 10/100/1000M
5 n Ports 1 & 16 Status LEDs Link/Act On When the Link/Act LED lights on, the respective port is successfully connected to an Ethernet networ
6 Installing the Web Management Utility Through the Web Browser you can configure the Switch such as VLAN, Trunking, QoS… etc. The following instru
7 PC must be set on the same IP network. For example, when the default network address of the default IP address of the Web Smart Switch is 192.168.0
8 Setup Menu When the main page appears, find the Setup menu in the left side of the screen (Figure 5). Click on the setup item that you want to con
Comments to this Manuals