D-Link AirPremier DAP-3690 User Manual

D-LinkAirPremierNConcurrentDualBandPoEOutdoorAPCLI Reference Guide

Commands and their Descriptions Wireless Commands Wireless Commands Descriptions config wlan config wlan (0:2.4G, 1:5G) d

get arrayp-sync-time Display AP Array sync time state get arrayp-sync-log Display AP Array sync log state get arrayp-sync-adminlimit Display AP Arra

get zonedefence-ip Display Zonedefence IP table list set acktimeout_a Set acktimeput in A band (range: 50--200) set acktimeout_g Set acktimeput in G

set ssidhidden Set SSID hidden set shortgi Set Shortgi set txpower Set TX power set wdsmacadd Add WDS MAC address <macaddress xx:xx:xx:xx:xx>[

set w_partition Set w_partition set wlan_utilization Set wlan utilization VLAN Commands VLAN Commands Description get vlanstate Display VLAN state g

get embradius Display Embedded RADIUS Server parameter get radiusip Display RADIUS server IP address get radiusport Display RADIUS port number set a

get daylightsaving Display daylight saving time get sntpserver Display SNTP/NTP server IP address get tzonelist Display time zone set daylightsaving

set dhcp_staticip_set_hostname Set DHCP static IP's host name set dhcp_staticip_set_ip Set DHCP static IP's IP set dhcp_staticip_set_mac S

set multi-priority Set priority of Multi-SSID[index] set priority Set priority of primary SSID set multi-w-partition Set wlan partition state of Mul

set multi-defkeyindex Set default key index [1-4] of Multi-SSID [index] set multi-backup-acctip Set backup accounting server IP of Multi-SSID [index

Notes, Notices, and Cautions Graphic Description NOTE: A NOTE indicates important information that helps you make better use of your computer. N

Access Control List Commands Access Control List Commands Description get acl Display ACL get macaddress Display MAC address get macaddrlist Display

Configuration Example The following configuration examples are provided to help first-time users get started. The user commands are in bold for eas

WAP0-> tftp putconfig dap3333690.dcf 1.49.12.1 tftp: The putconfig configuration file was successful. The following is an example of using TFTP

WAP0-> set cipher auto WAP0-> set radiusip 192.168.0.88 WAP0-> set radiussecret WAP0-> set apply The following is an example in whi

Table of Contents Contents Notes, Notices, and Cautions ...

Configuration Example ... 21

Command Groups Introduction The Command Line Interface (CLI) is a network management application operated through an ASCII terminal without the use

QoS Configures and displays QoS information RADIUS Configures and displays RADIUS information SNMP Configures SNMP communities, traps and displays S

Using a COM port to connect to DAP-3690 The back panel of the DAP-3690 provides an RJ45 Ethernet port to connect an RS-232 connector to your PC for

Hit the Enter key a couple of times to access the login phase Type admin at the login prompt and press the Enter key. Leave Password blank by de

Type “help” or use the question symbol, “?” then press Enter to access a list of commands. When you enter a command without all of its required p