D-Link DSL-2730B User Manual download pdf (Page 30)

Section 3 – Configuration

D-Link DSL-2730B User Manual

PPP Configuration

The parameters listed in the PPP Configuration menu are used for PPPoE and PPPoA connections.

PPP Username: Enter the account username in this field.

PPP Password: Enter the account password in this field.

PPPoE Service Name: Enter the service name here (optional).

Authentication Method: Choose the appropriate authentication method

here. If not sure leave this option on Auto.

Enable NAT: Tick this option to enable NAT for this connection. NAT is

enabled by default.

Enable Fullcone NAT: This option appears only if NAT is enabled (NAT is

enabled by default). Tick this option to enable Fullcone NAT for this

connection.

Enable Firewall: This is enabled by default. It provides basic firewall

protection that closes unused ports. Click in the box to remove the check

mark to disabled this function.

Dial on Demand: Tick this option to enable dial on demand for this

connection. When this is enabled, the PPP session will timeout and

disconnect when the connection is idle. It will automatically reconnect

whenever it receives a connection request from the LAN side.

Use Static IPv4: Tick this option to use a Static IP version 4 address for

this connection.

Static IPv4 Address: When Use Static IPv4 is selected, this selection

appears. Enter the Static IP version 4 address used here.

Enable IGMP Multicast: Tick this option to allow IGMP packets to go

through the WAN interface in both directions.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 105 106

No comments

D-Link DSL-2730B User Manual Page 30