D-Link DSM-312 User Manual download pdf (Page 20)

16D-Link DSM-312 User Manual

Section 2 - Installation

Ethernet Setup

If you have connected an Ethernet cable to the DSM-312 and either DHCP is not enabled on your router or the DSM-312 cannot

obtain an IP address, the Network Setting error message will appear.

Verify that your Ethernet connection is good. Check the link light on your router (or switch) is lit in the port that the DSM-312 is

connected to. Select Retry and press the OK button. If you still get an error message, select OK and press the OK button on your

remote.

If DHCP is disabled on your router, you will see the Select Connection Mode screen. Select Manual IP and press OK to enter the

IP settings manually (see below).

Step 1 - Select the IP box and press OK on your remote. Use the on-screen keyboard to enter an IP address for the DSM-312.

Select Enter and then press the OK button on your remote.

Step 2 - Repeat step 1 for (subnet) mask, gateway (usually the LAN IP address of your router), and DNS server (usually the LAN

IP address of your router).

Step 3 - Select Connect and press the OK button to save your settings and connect to your network.

If you still cannot connect and your Ethernet or wireless connection is good, check your settings in your router. Possibly MAC

address ltering may be enabled on your router and you will need to add the LAN MAC address of the DSM-312 to the lter list.

If DHCP is disabled on your router

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

No comments

D-Link DSM-312 User Manual Page 20