D-Link DCS 3110 User Manual download pdf (Page 62)

62D-Link DCS-3110 User Manual

Section 4 - Conﬁguration

With digital PTZ (Pan/Tilt/Zoom) feature enabled, it is possible to zoom

in and out video recieved from the DCS-3110.

Enable PTZ Operation

To utilize this feature, please connect the DCS-3110 to a PTZ scanner via

RS485 interface and follow the instructions given below. Three PTZ drivers are

supported:

• DynaDome/SmartDOME

• Lilin PIH-7x00

• Pelco D protocol

Note: If none of the above PTZ drivers is supported by your PTZ scanner, please

select Custom camera.

1. Connect to your PTZ scanner, set the Camera ID, PTZ driver, and Port

settings.

2. Select Enable PTZ Operation and then click Save to take effect.

3. The PTZ control buttons will be displayed in the main page.

Preset Position

Click Preset Position to set the preset position for the Network Camera. A total of

20 preset positions can be conﬁgured.

To set a preset position, follow the steps given below:

1. Adjust the Network Camera to a desired position using the buttons on the

right side of the window.

2. In the Preset position name text box, enter a descriptive name for the preset

position. You can enter up to 40 characters in the text box.

3. Click Add. The preset position name will appear in the drop-down list.

To remove a preset position from the list, select a preset position name from the

drop-down list and then click Delete.

RS485

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 87 88

No comments

D-Link DCS 3110 User Manual Page 62