D-Link DCS-6815 User Manual download pdf (Page 35)

35D-Link DCS-6815/6817/6818 User Manual

Section 3 - Conﬁguration

Snapshot

In order to enable your camera to take snapshots, you must select the checkbox marked Enable snapshot. Then, you can determine the

trigger event(s) email notication(s).

Select this checkbox to enable snapshots.

You may choose to trigger snapshots by motion detection or

D/I signal.

You must congure the SMTP server that you will use to

e-mail snapshots.

This is the SMTP username. Sometimes, this eld requires

a full e-mail address.

This is the password associated with the username above.

This is the address of the SMTP server. You may enter an IP

address or a DNS address.

This is the e-mail address that the mail will appear to be sent

from.

This is the e-mail address that the mail will be sent to.

This is the SMTP port that the server runs on. The default

value is 25.

Click this button to test the SMTP port. If a connection is

operable, the system will display the message "Success."

Note: The DCS-6815/DCS-6817/DCS-6818 do not

support SSL mail servers.

Enable Snapshot

Trigger By:

Remote SMTP

Setup:

Auth User:

Auth Password:

SMTP Server:

Sender’s Email:

Recipient’s Email:

SMTP Port:

Test SMTP:

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 49 50

No comments

D-Link DCS-6815 User Manual Page 35