D-Link DIR-120 User Manual download pdf (Page 72)

68D-Link DIR-860L User Manual

Section 3 - Conguration

This page will allow you to open a single port. If you would like to open a range of ports, refer to the next page.

Enter a name for the rule or select an application from the

drop-down menu. Select an application and click << to

populate the elds.

Enter the IP address of the computer on your local network

that you want to allow the incoming service to. If your

computer is receiving an IP address automatically from the

router (DHCP), your computer will be listed in the “Computer

Name” drop-down menu.

Enter the port that you want to open next to Private Port

and Public Port. The private and public ports are usually the

same. The public port is seen from the Internet side, and

the private port is used by the application on the computer

within your local network.

Select TCP, UDP, or Both from the drop-down menu.

The schedule of time when the Virtual Server Rule will be

enabled. The schedule may be set to Always, which will allow

the particular service to always be enabled. You can create

your own times in the Tools > Schedules section.

Select Allow All (most common) or a created Inbound lter.

You may create your own inbound lters in the Advanced >

Inbound Filter page.

Name:

IP Address:

Private Port/

Public Port:

Protocol:

Schedule:

Inbound Filter:

Virtual Server

Advanced

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 139 140

No comments

D-Link DIR-120 User Manual Page 72