D-Link DIR-100 User Manual download pdf (Page 23)

DIR-100 Ethernet Broadband Router

Setup Wizard – Configure L2TP Client Connection

NOTE: The broadband device used for your Cable or ADSL network

connection must support L2TP pass-through so the VPN session can be

established.

The Router supports Layer 2 Tunneling Protocol (L2TP) for the Internet connection. L2TP is also used for

Virtual Private Networks (VPN). Some ISPs use L2TP to establish a client-to-server connection to their

network, and ultimately to the Internet. If your Internet connection comes through a L2TP client connection

to a server owned by your ISP, the IP settings and user account information must be pre-configured on the

remote server before network access is granted.

To configure the L2TP client connection, enter the IP and account information for the Router. Your ISP will

give this information to you if you are establishing a L2TP connection to the ISP. Click Next to continue.

L2TP Connection Setting Description

My IP Address

Enter the IP address for your DIR-100 based on the

information provided to you by your ISP.

Subnet Mask

Enter the Subnet Mask for your DIR-100 based on the

information provided to you by your ISP.

Gateway IP Address

Enter the Gateway IP address based on the information

provided to you by your ISP.

Server IP Address

Enter the IP address of the ISP server with which your router

will be conveying encrypted information. This field is based on

information provided to you by your ISP.

L2TP Account

Enter the name of the L2TP account as provided to you by

your ISP.

L2TP Password

Enter the L2TP password as provided to you by your ISP.

Retype Password

Retype the password entered in the Password field.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 69 70

No comments

D-Link DIR-100 User Manual Page 23