D-Link DVG-N5412SP Installation Guide download pdf (Page 2)

Front Panel

Power：Solid indicates a connection to a good power source.

Prov./Alm：A blinking light indicates the DVG-N5412SP can not register with SIP Server or

can not get the IP address. A blinking light also indicates the DVG-N5412SP is attempting

to connect with the Provisioning server. Once the service connects, the LED will turn off.

The LED will light solid red if the self-test or boot-up fails.

Reg.：The Register LED will turn on and continuously working when DVG-N5412SP is

connected to a VoIP service provider. The LED will flash if not connected to a service

provider.

WAN：When a connection is established the LED will light up solid. The LED will blink to

indicate activity. If the LED does not light up when a cable is connected, verify the cable

connections and make sure your devices are powered on.

WLAN：A steady light indicates a wireless connection. A blinking light indicates that DVG-

N5412SP is receiving/ transmitting from/to the wireless network

LAN：When a connection is established the LED will light up solid on the appropriate port.

The LEDs will blink to indicate activity. If the LED does not light up when a cable is

connected, verify the cable connections and make sure your devices are powered on.

USB：This indicates that DVG-N5412SP detects a supported 3G USB dungle or a USB

device.

Phone：This LED displays the VoIP status and Hook activity on the phone port that is used

to connect your normal telephone(s). If a phone connected to a phone port is off hook or in

use, this LED will light solid. When a phone is ringing, the indicator will blink.

Line：Light on means the line is in use (off-hook).

WPS: Flashing in blue as DVG-N5412SP processing WPS-PBC wireless connecting

progress.

Hardware Overview

1 2 3 4 5 6 7 ... 10 11

No comments

D-Link DVG-N5412SP Installation Guide Page 2