D-Link DCH-M225 User Manual download pdf (Page 24)

20D-Link DCH-M225 User Manual

Section 2 - Product Setup

WPS Button

3. The DCH-M225 uses the push-button method for WPS. Press and

hold the WPS button on your wireless router or access point

until the light starts blinking green. Allow up to two minutes

for the WPS process to nish. When a connection is successfully

established, the LED on the device should turn solid green.

Note: Refer to your router or access point’s user manual instructions

for more information about the WPS process.

4. If your wireless device does not support WPS, click Select this

option if you want to set up your network manually.

Click Next to continue.

5. Wait while your DCH-M225 scans for available Wi-Fi networks. You

will see a list of networks found. Select the Wi-Fi Network you

wish to use, click Select.

Note: If the network you would like to connect to isn’t listed, click

Back and select the manual option again to perform another scan.

Make sure you are in range of your wireless router.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 68 69

No comments

D-Link DCH-M225 User Manual Page 24