D-Link DCH-M225 User Manual download pdf (Page 32)

29D-Link DCH-M225 User Manual

Section 3 - Web-based Conguration

Network Settings

This page lets you congure the network settings for the DCH-M225. To access this page, click on the Settings drop-down

menu at the top of the page, and select Network. Click Save at any time to save the changes you have made on this page.

Device Name: You can change the name of the device by editing the text in

the text box. If you change the name of the device, you will

need to enter “http://xxxx.local.” (where “xxxx” corresponds

to the name of the device) in the address bar of your web

browser in order to access the conguration utility.

Advanced Settings

The Advanced Settings section of the Network Settings page allows you to congure both IPv4 and IPv6 settings which will

be used by the DCH-M225’s extended network.

IPv4 Device Management interface - You can select either a Dynamic or Static IPv4 conguration:

My LAN

Connection is:

IP Address:

Subnet Mask:

Gateway

Address:

Primary DNS

Server:

Secondary

DNS Server:

Here you can select whether you want the IP to have a

Dynamic IP or Static IP address. If you select Dynamic IP,

the options below will not be available.

Enter the Static IP address that you want to assign to the

extended network AP. This address should be outside of the

uplink router’s DHCP address pool.

Enter the subnet mask.

Enter the gateway address. This is usually the IP address of

the uplink router.

Enter the address of the primary DNS server.

Enter the address of the secondary DNS server. This is

optional but will provide backup if the primary server fails.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 54 55

No comments

D-Link DCH-M225 User Manual Page 32