D-Link DGS-1248T - Switch User's Guide download pdf (Page 14)

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators of the

Switch.

Front Panel

The figure below shows the front panels of the Switch.

10/100/1000 Base-T Twisted-Pair Ports w/ LED Indicators

┌─────────────────────────────┐

└──┘

SFP(Mini GBIC) Ports

Figure 4. Front panel of 48-Port Gigabit Ethernet Switch

LED Indicator:

Comprehensive LED indicators display the status of the Switch and the

network (see the LED Indicators chapter below).

1000BASE-T Twisted Pair Ports (Port 1~48)

The DGS-1248T is equipped with fourty-eight Gigabit twisted pair ports that

are auto negotiable 10/100/1000Mbps and also support auto MDI/MDIX

crossover detection. These ports can operate in half- and full-duplex modes.

SFP(Mini GBIC) Ports (Option Port 45~48)

The Switch is equipped with Four SFP(Mini GBIC) ports, supporting

optional 1000BASE-X SFP(Mini GBIC) transceivers.

Note: When the port is set to “Forced Mode”, Auto MDI/MDIX will be disabled.

Reset:

The Reset button is used to reset all settings back to the factory defaults.

Note: Be sure that you record the settings of your device, or else all settings

will be erased when pressing the “Reset” button.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

D-Link DGS-1248T - Switch User's Guide Page 14