D-Link DHN-520 User's Guide download pdf (Page 11)

D-Link DHN-520 10Mb Home Phoneline Network Adapter for the PCI Bus

Install the Adapter

1. Shut down the computer, unplug its power cord, and remove the chassis cover.

2. Insert the contact edge of the D-Link DHN-520 card into the connector of any

available PCI Bus Master expansion slot. Press the card firmly into the

connector and ascertain that the card and contacts are fully seated in the

connector.

3. Install the bracket screw that secures the card to the computer chassis.

4. Replace the computer's chassis cover.

5. Reconnect the computer's power cord, and turn the computer on. If the BIOS

section of your computer's boot program is Plug and Play compliant, then at

power-up the BIOS will automatically configure any newly installed D~Link

DHN-520 adapter.

NOTE: Due to a fault in some Plug-n-Play BIOS programs, occasionally a newly installed

adapter is assigned an Interrupt Number which is already assigned to another

device. In such a case, the conflict of Interrupt Number will cause faults in the

behavior of both devices. It will then be necessary to run the CMOS Setup utility,

and manually assign a non-conflicting Interrupt Number.

Connect the Phoneline Cable

Standard phoneline cable can be used to either connect the adapter to a phoneline

wall jack, or to another adapter.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

No comments

D-Link DHN-520 User's Guide Page 11