D-Link DNS-1100-04 User Manual download pdf (Page 5)

D-Link DNS-1100-04 Quick Installation Guide

3. Hardware Installation

Follow the instructions below to install a hard drive, connect to the network and power on

the ShareCenter. Open the shipping carton for the ShareCenter® Pro and carefully remove

and unwrap its contents. Follow the instructions below to setup the ShareCenter® Pro. If this is

the rst time using the ShareCenter® Pro or if a new hard disk is installed, use the Easy Search

utility located on the Installation CD and follow the instructions for setting up, conguring and

formatting the new drive.

To install ShareCenter® Pro on your local network, refer to the steps below:

2. Remove the HDD tray by pressing the green button.

1. Open the faceplate to access the drive bays.

3. Put a 3.5” SATA hard drive into a drive tray and use screws

to fasten the hard drive with the tray. There are four holes

for fastening the screws. Two holes are circled in red in

the image, and the other two holes are on the other side

of the drive tray.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

D-Link DNS-1100-04 User Manual Page 5