D-Link DVG-2032S User Manual download pdf (Page 7)

Hardware Description

Front Panel

 Power Indicator: Green light indicates a normal power supply.

 Run Indicator: Blinking green light indicates normal operation.

 Alarm Indicator: When the system starts up, the red light will blink. It also indicates the

gateway’s abnormal operation.

 P1 – P32 stands for Port 1 – Port 32: Connect to your analog telephone.

 WAN stands for the WAN Port Indicator.

 LAN stands for the LAN Port Indicator.

 When starting up the system, the Alarm, Run, and Power indicators will light up.

After about 40 seconds, the Alarm indicator will go off, the Run indicator will blink

in green, and the Power indicator will stay green under normal operational

conditions. If the Alarm indicator continues to blink, it means the system is

currently communicating with ISP and has yet to obtain an IP address.

 When the WAN is connected, the WAN indicator will light up in green and if data is

being transmitted over the Internet, the indicator blinks in green and orange.

Rear Panel

NOTE: Do not connect Phone ports to each other. Also, do not connect any Phone ports

directly to a PSTN line or internal PBX. If any of these are done, your DVG-2032S may be

damaged.

Restore to factory default: (IP address, User’s. Name and Password)

(1) Pull off the power plug.

(2) Press reset (do not let go of the reset button).

(3) Plug the plug back into the socket (do not let go of the reset button).

(4) Let go of the reset button after 6 seconds. Factory settings will be restored.

1 2 3 4 5 6 7 8 9 10 11 12 ... 50 51

No comments

D-Link DVG-2032S User Manual Page 7