D-Link DIR-100 User Manual download pdf (Page 30)

DIR-100 Ethernet Broadband Router

PPPoE connection setup menu

To configure a PPPoE Internet connection, follow these steps:

1. Select the PPPoE (Username / Password) option from the My Internet Connection is: pull-down

menu.

2. Choose the IP address assignment option (Dynamic PpoE or Static PPPoE). Static IP address

assignement requires manual entry of IP settings information.

3. Under the PPPoE heading, type the User Name and Password used for your account. A typical

User Name will be in the form

[email protected]. The Password may be assigned to you by your

ISP or you may have selected it when you set up the account with your ISP. Type the password

again in Confirm Password.

4. For Static PPPoE connections, enter IP settings provided by the ISP and, if necessary enter MAC

address (see table below)

5. Leave the MTU value at the default setting (default = 1492) unless you have specific reasons to

change this (see table below for more information).

6. Choose the desired Connection Setting. Select from: Always ON, Connection On Demand, or

Manual. Most users will want to choose the default connection setting, Always ON.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 69 70

No comments

D-Link DIR-100 User Manual Page 30