D-Link DIR-857 User Manual download pdf (Page 55)

50D-Link DIR-857 User Manual

Section 3 - Conguration

This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.

Enter a name for the rule or select an application from the drop-

down menu. Select an application and click << to populate the

elds.

Enter the IP address of the computer on your local network

that you want to allow the incoming service to. If your

computer is receiving an IP address automatically from the

router (DHCP), you computer will be listed in the “Computer

Name” drop-down menu. Select your computer and click <<.

Enter the port that you want to open next to Private Port and

Public Port. The private and public ports are usually the same.

The public port is the port seen from the Internet side, and

the private port is the port being used by the application on

the computer within your local network.

Select TCP, UDP, or Both from the drop-down menu.

Select Allow All (most common) or a created Inbound lter.

You may create your own inbound lters in the Advanced

> Inbound Filter page.

The schedule of time when the Virtual Server Rule will be

enabled. The schedule may be set to Always, which will allow

the particular service to always be enabled. You can create

your own times in the Tools > Schedules section.

Name:

IP Address:

Private Port/

Public Port:

Protocol Type:

Inbound Filter:

Schedule:

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 122 123

No comments

D-Link DIR-857 User Manual Page 55