D-Link DSL-2540U User Manual download pdf (Page 64)

Appendix A – Troubleshooting

D-Link DSL-2540U User Manual

Troubleshooting

This chapter provides solutions to problems that might occur during the installation and operation of the DSL-2540U. Read the following

descriptions if you are having problems. (The examples below are illustrated in Windows® XP. If you have a different operating system, the

screenshots on your computer will look similar to the following examples.)

1. How do I configure my DSL-2540U Router without the CD-ROM?

• Connect your PC to the Router using an Ethernet cable.

• Open a web browser and enter the address http://192.168.1.1

• The default username is ‘admin’ and the default password is ‘admin’.

• If you have changed the password and cannot remember it, you will need to reset the Router to the factory default setting (see question 2),

which will set the password back to ‘admin’.

Note: Please refer to the next section “Networking Basics” to check your PC’s IP configuration if you can’t see the login windows.

2. How do I reset my Router to the factory default settings?

• Ensure the Router is powered on.

• Press and hold the reset button on the back of the device for approximately 5 to 8 seconds.

• This process should take around 30~60 seconds.

3. What can I do if my Router is not working correctly?

There are a few quick steps you can take to try and resolve any issues:

• Follow the directions in Question 2 to reset the Router.

• Check that all the cables are firmly connected at both ends.

• Check the LEDs on the front of the Router. The Power indicator should be on, the Status indicator should flash, and the DSL and LAN

indicators should be on as well.

• Please ensure that the settings in the Web-based configuration manager, e.g. ISP username and password, are the same as the settings

that have been provided by your ISP.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69

No comments

D-Link DSL-2540U User Manual Page 64