D-Link DSL-2740U Installation Guide download pdf (Page 9)

DSL-2740U Quick Installation Guide

PC with Wi-Fi Adapter

1. To connect the router to a DSL line: connect a phone cable between the

DSL port of the router and the ADSL OUT port of the splitter. Connect

your phone to the PHONE port of the splitter. Then connect another

phone cable between a phone jack and the ADSL IN port of the splitter.

2. To connect the router to an Ethernet line: connect the Ethernet cable

between any of four Ethernet ports located on the back panel of the router

and the Ethernet line.

3. Connect the power cord to the power connector port on the back panel of

the router, then plug the power adapter into an electrical outlet or power

strip.

4. Turn on the router by pressing the ON/OFF button on its back panel.

5. Turn on Wi-Fi by pressing the relevant button on the back panel of the

router.

6. Turn on your PC and wait until your operating system is completely

loaded.

7. Turn on your Wi-Fi adapter. As a rule, modern notebooks with built-in

wireless NICs are equipped with a button or switch that turns on/off the

wireless adapter (refer to your PC documents). If your PC is equipped

with a pluggable wireless NIC, install the software provided with your

Wi-Fi adapter.

Now you should configure your Wi-Fi adapter.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

No comments

D-Link DSL-2740U Installation Guide Page 9