D-Link DAP-3220 User Manual download pdf (Page 60)

DAP-3220 User’s Manual

D-Link Wireless 108G Exterior Access Point

Troubleshooting

2. The wireless client cannot access the Internet within Infrastructure mode.

Make sure the wireless client is associated and joined with the correct access point. To check

this connection, right-click on the Local Area Connection icon in the taskbar and select View

Available Wireless Networks. The Connect to Wireless Network screen will appear. Please

make sure you have selected the correct available network, as shown in the illustrations below.

Check that the IP address assigned to the wireless adapter is within the same IP address

range as the access point and gateway. Since the DAP-3220 has an IP address of

192.168.0.50, wireless adapters must have an IP address in the same range, e.g. 192.168.0.x.

Each device must have a unique IP address; there may be no two devices with the same

IP address. The subnet mask must be the same for all the computers on the network. To

check the IP address assigned to the wireless adapter, double-click on the Local Area

Connection icon in the taskbar, then select the Support tab and the IP address will be

displayed.

Please refer to Checking the IP Address in the Networking Basics section of

this manual.

If it is necessary to assign a Static IP Address to the wireless adapter, please refer to the

appropriate section in Networking Basics. If you are entering a DNS Server address you

must also enter the Default Gateway Address.

Remember that if you have a DHCP-capable

router, you will not need to assign a static IP address. See Networking Basics: Assigning

a Static IP Address.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 68 69

No comments

D-Link DAP-3220 User Manual Page 60