D-Link DWL-1000AP+ Installation Guide download pdf (Page 26)

Check that the Ethernet LED on the DWL-1000AP+ is ON. If the

LED is not ON, check that the cable for the Ethernet connection

is securely inserted.

Check that the Ethernet Adapter is working properly. Please see

item 3 (Check that the drivers for the network adapters are

installed properly) in this Troubleshooting section to check

that the drivers are loaded properly.

Check that the IP Address is in the same range and subnet

as the DWL-1000AP+. Please see Checking the IP Address

in Windows XP in the Networking Basics section of this

manual.

Do a Ping test to make sure that the DWL-1000AP+ is

responding. Go to Start>Run>Type Command>Type ping

192.168.0.50. A successful ping will show four replies.

Troubleshooting

Note: It is recommended that you use an Ethernet connection to conﬁgure

the DWL-1000AP+ Access Point.

1. The computer used to conﬁgure the DWL-1000AP+ cannot access

the Conﬁguration menu.

Note: The IP Address of the DWL-1000AP+ is 192.168.0.50. All the computers on

the network must have a unique IP Address in the same range, e.g., 192.168.0.x.

Any computers that have identical IP Addresses will not be visible on the network.

They must all have the same subnet mask, e.g., 255.255.255.0

This chapter provides solutions to problems that can occur during the instal-

lation and operation of the DWL-1000AP+. We cover various aspects of the

network including network adapters. (The examples below are illustrated in

Windows XP. If you have another operating system, these solutions will still

apply although the appearance on your computer screen may differ.)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

No comments

D-Link DWL-1000AP+ Installation Guide Page 26