D-Link DWL-1000AP+ Installation Guide download pdf (Page 27)

2. The wireless client cannot access the Internet in the Infrastructure

mode.

Make sure the wireless client is associated and joined with the

correct Access Point. To check this connection: Right-click on the

Local Area Connection icon in the taskbar> select View Available

Wireless Networks. The Connect to Wireless Network screen

will appear. Please make sure you have selected the correct

available network, as shown in the illustrations below.

Troubleshooting (continued)

If it is necessary to assign a Static IP Address to the wireless

adapter, please refer to the instructions on the following page.

Check that the IP Address assigned to the wireless adapter is within

the same IP Address range as the access point and gateway.

Since the DWL-1000AP+ has an IP Address of 192.168.0.50,

wireless adapters must have an IP Address in the same range,

e.g., 192.168.0.x. Each device must have a unique IP Address;

no two devices may have the same IP Address. The subnet mask

must be the same for all the computers on the network.) To check

the IP Address assigned to the wireless adapter, double-click

on the Local Area Connection icon in the taskbar > select the

Support tab and the IP Address will be displayed. (Please refer

to Checking the IP Address in the Networking Basics section of

this manual.)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

No comments

D-Link DWL-1000AP+ Installation Guide Page 27