D-Link DWL-A520 Specifications download pdf (Page 13)

2. A Home Internet Network with Multiple IP Addresses (continued)

Please follow these steps to complete the installation:

1. Connect the Wireless Access Point (the D-Link AirPro DWL-

5000AP is shown in the example) to a Broadband connection (i.e., a

Cable modem such as the D-Link DCM-200 cable modem.)

2. Install the D-Link AirPro DWL-A520 Wireless PCI Adapter into a

desktop computer on your wireless network. (You can also install the

D-Link AirPro DWL-A650 Wireless Cardbus Adapter into a laptop

computer. Please refer to the Quick Install Guide included with each

product.)

3. Check the Device Manager to confirm that the wireless adapter is

installed correctly. Please refer to the Networking Basics section in

this manual entitled: Checking the Installation of the Drivers for

the Wireless Adapter.

4. Set the Static IP Address of the wireless adapters. Please refer to

the Networking Basics section in this manual entitled: Assigning

an IP Address.

Note: The IP Address for all computers must be in the same IP Address

range, and the Subnet Mask must be the same for all the computers on the

network. For example: If the first computer is assigned an IP Address of

192.168.0.2 with a Subnet Mask of 255.255.255.0, then the second

computer can be assigned an IP Address of 192.168.0.3 with a Subnet Mask

of 255.255.255.0, etc.

If you are using a PPPoE client (Point to Point Protocol over Ethernet)

please contact your ISP (Internet Service Provider) for further instructions

regarding connecting to the Internet.

5. Learn to share printers and files. Please refer to the Networking

Basics section in this manual entitled: Adding and Sharing Printers

in Windows XP.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 62 63

No comments

D-Link DWL-A520 Specifications Page 13