NetworkSecurity FirewallThis Quick Guide will guide you through the installation Process. You are only moments away from using your new D-Link Network
2Step 3 - Set up time and dateClick Set time and date button for setting device08Click NextSelect the appropriate dateEnter the appropriate timeClick
Step 4 - Set up timezoneStep 5 - Select WAN interfaceSelect the appropriate timezone.Enter the appropriate dayligt saving time settings.Select the WAN
Step 6 - Confi gure WAN interfaceSelect the appropriate confi guration for the WAN interface, Click Next and continue to step 7.1 further down.Note: If
Step 7.2 - WAN Interface Type is PPPoEStep 7.3 - WAN Interface Type is PPTPIf you selected PPPoE (Point-to-Point Protocol over Ethernet) you will have
Step 7.4 - WAN Interface Type is Big PondStep 8 - Set up built-in DHCP serverIf you selected Big Pond you will have to fi ll out the user name and pass
Step 9 - Confi gure helper serversStep10 - Setup Wizard CompleteNTP ServersIf enabled, specify which NTP Servers that should be used to syncronize the
Appendix5To connect to the DFL-800 Network Security Firewall, make sure the network adapter in your computer is confi gured properly. Here is how to co
Note:Except for 192.168.1.1, you could set your PC with any IP addresses that same as the 192.168.0.0/ 255.255.255.0 subnet.Select Use the following I
Set IP Address to 192.168.1.30,Subnet Mask to 255.255.255.0and Router to 192.168.1.1.Click on Apply NowDFL-800 Quick Installation GuideSelect Built-in
WARRANTY6WarrantyFCC WarningThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to P
1.Before You Begin 1.1 Check Your Package Contents...12.Indentifying Components2.1
Attenzione!Il presente prodotto appartiene alla classe B. Se utilizzato in ambiente domestico il prodotto può causare interferenze radio, nel cui caso
1.1 Check Your Package ContentsYour NetDefend Network Security Firewall package should contain all the items listed below. If any of these items is f
Identifying Components2The following illustrates the front panel of the DFL-800 and explains the front panel’s key components:2.1 Front View1 2 3 4 5
2.3 Default Interface Attribute definitionNote: For security reason, default only allow LAN interface (192.168.1.1) that can login into firewall GUI f
3.1 Connecting Firewall to Your NetworkA. First, connect the power cord to the receptor at the back panel of the DFL-800 and then plug the other en
4.1 Configure Your Computer’s IP AddressMake sure that the network adapter in your computer is configured to use a static IP address with 192.168.1.1
4.2 Using the Setup WizardThe DFL-800 provides Web based confi guration. You can confi gure your DFL-800 through Internet Explorer 6 or Firefox 1.0 bro
Step1 - Welcome to the DFL-800 setup wizard!Step2 - Set up fi rewall administrator passwordFirst Enter the username that you want to use for the admin
Comments to this Manuals