DSS-24 10/100 Auto Negotiation Switch User’s Guide
Introduction
Side Panel
There are two fans. The fans come on when the DSS-24 is powered on. The three
holes on each side of the DSS-24 are used to attach the mounting brackets.
There are heat vents located on the side opposite the fans. The fans and the heat
vents help to cool the DSS-24. Always leave two inches of space around the DSS-
24 for air circulation.
Figure 2: Side Panel
Rear Panel
The three pronged power plug, female RS-232 Console port and rear fan are
located at the rear of the DSS-24, shown in Figure 3. During installation, leave
enough room to allow you to plug in the power cable and attach the RS-232 cable
for Local Console Management.
Figure 3: Rear View
Comments to this Manuals