D-Link DSS-24+ User's Guide download pdf (Page 17)

DSS-24 10/100 Auto Negotiation Switch User’s Guide

Installing the DSS-16 and DSS-24

Power On

The power supply will adjust to the local power source automatically. The DSS-

24 may be plugged in without having any or with all LAN segment cables

connected.

The power plug is located at the rear of the DSS-24. Plug the cable into the wall

socket and plug the other end into the DSS-24. There is no on/off switch. The

DSS-24 powers on when you plug the power cord into the three pronged power

connector. The Power LED will light when the DSS-24 is powered on. All ports

will automatically negotiate the proper speed and duplex mode.

Reboot the DSS-24 if there is a problem. Contact D-Link Systems, Inc. for

technical support.

After a power failure, it may be necessary to reconfigure any ports that were

manually set. All other ports should automatically negotiate the proper speed and

duplex mode.

The DSS-24 can be used with power sources in the range 100 to 240 VAC., 50 to

60 Hz.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

No comments

D-Link DSS-24+ User's Guide Page 17