D-Link DIR-655 User Manual download pdf (Page 28)

24D-Link DIR-655 User Manual

Section 3 - Conguration

Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS

server addresses. In most cases, select Dynamic.

Enter the L2TP IP address supplied by your ISP (Static only).

Enter the Subnet Mask supplied by your ISP (Static only).

Enter the Gateway IP Address provided by your ISP.

Enter the Server IP provided by your ISP (optional).

Enter your L2TP username.

Enter your L2TP password and then retype the password in the next box.

Select either Always-on, On-Demand, or Manual.

Enter a maximum idle time during which the Internet connection is maintained during

inactivity. To disable this feature, enable Auto-reconnect.

Enter the Primary and Secondary DNS Server Addresses (Static L2TP only).

Maximum Transmission Unit - you may need to change the MTU for optimal

performance with your specic ISP. 1400 is the default MTU.

The default MAC Address is set to the Internet port’s physical interface MAC address on

the Broadband Router. It is not recommended that you change the default MAC address

unless required by your ISP. You can use the Clone Your PC’s MAC Address button to

replace the Internet port’s MAC address with the MAC address of your Ethernet card.

Address Mode:

L2TP IP Address:

L2TP Subnet Mask:

L2TP Gateway:

L2TP Server IP:

Username:

Password:

Reconnect Mode:

Maximum Idle Time:

DNS Servers:

MTU:

Clone MAC Address:

L2TP

Choose L2TP (Layer 2 Tunneling Protocol) if your ISP uses a L2TP connection. Your ISP will provide you with a username and password. This option

is typically used for DSL services.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 133 134

No comments

D-Link DIR-655 User Manual Page 28