D-Link DCS-1000 User's Guide download pdf (Page 46)

How to Snap shot a Camera

Snap shot Camera

To snap shot a camera you must highlight the camera you wish to snap shot

from the list view format. From the menu bar select “Camera” > “Snap

shot”. A Save Image dialog box will appear for you to save the snap shot

picture.

A second alternative is from the viewing mode either 1, 4, 9, 16 cameras click

on the icon located on the upper left corner of the screen and a case sensitive

menu will appear and select the “Snap shot” icon. A Save Image dialog box

will appear for you to save the snap shot picture.

Note:

Alternatively you can click the Snap shot icon as illustrated or use the hot

key “F5 ”.

How to Adjust the Property Setting

Property Setting

“Property” is initiated by selecting “Camera” > “Property” and a dialog

box will appear allowing settings of Web Configuration and upgrade firmware

(Please refer to the appendix for detailed information). The Camera

Property dialog box will appear for you to select the desired options from the

tab selections to Configure the camera as shown below.

General

Allows settings for the camera name, location and administrator information

such as administrator ID and password. Please refer to the Web Configuration

section under “System Administration – System” for further details.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 82 83

No comments

D-Link DCS-1000 User's Guide Page 46