D-Link DCS-1000 User's Guide download pdf (Page 8)

DC Power Connector

The DC power input connector is located on DCS-1000’s rear panel and is

labeled DC 5V with a single jack socket to supply power to DCS-1000.

Reset Button

Reset will be initiated when the reset button is pressed once and Power LED

begins to flash.

Factory Reset will be initiated when the reset button is pressed continuously

for three seconds or when Power LED begins to light up. Release the reset

button and the Power LED will begin to flash indicating DCS-1000 is

changing to factory reset. When factory reset is completed the IP address will

return to the default setting as 192.168.0.20.

I/O Connector

There are four I/O connectors, two for input and two for output situated on the

rear panel. The I/O connectors provide the physical interface to send and

receive digital signals to a variety of external alarm devices. Please refer to

the User’s Guide appendix for detailed information.

Bottom Panel

Screw Hole

Located on the bottom panel of DCS-1000 the screw hole is used to connect

the camera stand onto DCS-1000 by attaching the screw head on the camera

stand into the screw hole of DCS-1000.

Screw Hole

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 82 83

No comments

D-Link DCS-1000 User's Guide Page 8