D-Link DVS-301 User Manual download pdf (Page 22)

Building Networks for People

DVS-301 User Manual v1.00

Modem Environment

Hardware installation

Before installing Video Server, the administrator should memorize the MAC address on the

packages respectively for the initial passwords.

To use a dial-up network, the Ethernet socket should be left disconnected since Ethernet is the

first priority among available interfaces. After powering up, Video Server will detect if any

external modem is connected to the modem port. Once a modem is detected, the heartbeat

LED will flash periodically. If no modem responds, Video Server will assume the included null

modem cable is connected to perform system configuration. Then both lower LEDs will turn on

until null modem connection is established.

If users have setup a remote dialup server or subscribed to an ISP service, Video Server can be

configured to dial to the server upon special events. Otherwise it will wait permanently for the

user’s call to establish a network connection to provide services.

In the following content, dial-in connection denotes a passive Video Server waiting for a phone

call to establish a point-to-point connection. Dial-out connection denotes an active Video Server

to dial out to the other end of a dial-up server or any Internet service provider, abbreviated as

ISP, to request a point-to-point connection.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

No comments

D-Link DVS-301 User Manual Page 22