D-Link DVS-301 User Manual download pdf (Page 86)

Building Networks for People

DVS-301 User Manual v1.00

Appendix

A. POST procedure

After the power has been turned on, Video Server will perform a self-diagnostic to locate any

possible hardware defects. If the power indicator is dim at the beginning, the power fails to

proceed further. While the POST is proceeding, the status LED indicators will keep blinking

interchanged until finished or any fatal error happens. If either status LED indicator is dim at the

beginning, the LED may be broken.

Any possible fatal error has a special pattern shown in the following table. LED2 is the one

below the network indicator and LED3 is the lowest one. If the POST is successful, status LED

indicators will both shut off for a while and then light depending on the chosen network interface.

If Ethernet is available, LED2 will flash like a heartbeat after network installation is done.

Otherwise if modem is available, LED2 will flash alike to indicate listening for dial-in connection

while LED3 is lit. If the included null modem cable is connected, both LEDs will stay on and then

LED2 will start flashing after the connection from the PC is opened for configuration and LED3

stays lit.

LED pattern after POST Possible failed component Failed function

LED2 and LED3 blink at same

time

U32(SAA7113) Video decoder

LED2 ON and LED3 OFF U1(TM1300) PCI bridge of TM1300

LED2 OFF and LED3 ON U6(RTL8139C) Ethernet controller

LED2 ON and LED3 ON U6(RTL8139C), U7, U8 Ethernet interface*

LED2 blink and LED3 ON U22(M5823) Real-time clock

LED2 ON and LED3 blink U19(16C1550CJ), P2 COM interface

Ethernet interface failure includes not only components on board but also Ethernet cable

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

No comments

D-Link DVS-301 User Manual Page 86