D-Link DES-7100 User Manual download pdf (Page 12)

DES-7000/DES-7100 Layer 2 Switch User’s Guide

Unpacking and Setup

Setup

The DES-7000 is shipped with the DES-7003 management module preinstalled. There are some

additional pieces that the user may opt to install. These are described below. The Quick Installation

Guide included with the switch contains illustrations and information that may be useful for installing

the additional hardware.

Make sure the location used is a suitable environment for the Switch and there is adequate ventilation.

Have the necessary cabling required to connect the Switch to the network.

You may install DES-7000 series network modules at any time before or after the switch has been

installed and powered on. Modules can be hot swapped to meet the changing demands of the network.

Attaching Wheels

The DES-7000 is shipped with four wheels that may

be install but are not required. To install the wheels,

gently place the chassis on either of its sides to

access the wheel mounts. Make sure the fan module

is firmly in place before tilting the chassis. Each

wheel is held in place with four screws (included in

the package with the wheels).

Rack Installation

The chassis may be placed into a standard 19”

equipment rack with or without the wheels attached.

The ears at the front of both sides of the chassis

should be used to hold it firmly in place with screws.

Figure 2 - 2. DES-7000 Switch Chassis with optional wheels

Cable Bearer

The cable bearer is attached to the top of the chassis front panel on the DES-7000 chassis. Use the

four screws included in the packaging.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 110 111

No comments

D-Link DES-7100 User Manual Page 12