D-Link DES-7100 User Manual download pdf (Page 35)

DES-7000/DES-7100 Layer 2 Switch User’s Guide

Switch Management

Basic Switch Information

The switch's MAC address can also be found along with other basic information about the Switch

using CLI as shown below. Basic switch information may be listed using the command show switch.

Figure 5- 3. Basic Switch Information Screen

Information about installed modules can be viewed with the show unit_information command.

Modules are listed by slot number and include information on the unit type, Prom code version,

Runtime code version and hardware version.

Figure 5- 4. Unit Information

Remote Management

Remote management through the Web-based management software or Telnet is enabled by default.

Once you have the IP settings of the Switch configured you can use either of these methods to

manage the Switch. In-band management can be done remotely through the network using Telnet the

web-based management. You may also use a Telnet or web interface for out-of-band management by

connecting directly to the Switch’s dedicated Management port (labeled Mgmt) on the Primary Master

CPU module. The Mgmt port is an RJ-45 connection with auto-polarity detection so you can use

standard Ethernet cable to connect it to the Ethernet port on a desktop PC or notebook computer.

Telnet uses the same CLI commands you would use for the console connection. See the CLI

Reference Guide for a complete list of commands. The following chapter describes how to access the

Web-based management interface.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 110 111

No comments

D-Link DES-7100 User Manual Page 35