D-Link DGS-3000-10TC Technical Information download pdf (Page 222)

DGS-3000 Series Layer 2 Managed Gigabit Switch Web UI Reference Guide

214

Figure 8-43 JWAC Port Settings window

The fields that can be configured are described below:

Parameter Description

From Port / To Port

Use the drop-down menus to select a range of ports to be enabled as JWAC ports.

State

Use this drop-down menu to enable the configured ports as JWAC ports.

Max Authenticating

Host (0-50)

Enter the maximum number of host that process authentication on each port at the

same time.

Aging Time (1-1440)

Specify the time period during which an authenticated host will remain in the

authenticated state. Enter a value between 1and 1440 minutes. Tick the Infinite check

box to indicate the authenticated host will never age out on the port. The default value

is 1440 minutes (24 hours).

Idle Time (1-1440)

If there is no traffic during the Idle Time parameter, the host will be moved back to the

unauthenticated state. Enter a value between 1 and 1440 minutes. Tick the Infinite

check box to indicate the Idle state of the authenticated host on the port will never be

checked. The default value is infinite.

Block Time (0-300)

This parameter is the period of time a host will be blocked if it fails to pass

authentication. Enter a value between 0 and 300 seconds. The default value is 60

seconds.

Authentication

Mode

Use the drop-down menus to select the port authentication mode to be either Host-

based or Port-based.

Click the Apply button to accept the changes made.

JWAC User Settings

This window is used to configure JWAC user settings for the Switch.

To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC User Settings as

shown below:

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 333 334

No comments

D-Link DGS-3000-10TC Technical Information Page 222