D-Link DAP-1150 User Manual download pdf (Page 54)

54D-Link DAP-1150 User Manual

Section 3 - Conguration

The Host Name is optional but may be required by some

ISPs. The default host name is the device name of the

Router and may be changed.

The default MAC Address is set to the WAN’s physical

interface MAC address on the Broadband Router. It is not

recommended that you change the default MAC address

unless required by your ISP.

The default MAC address is set to the WAN’s physical

interface MAC address on the Broadband Router. You

can use the “Clone MAC Address” button to copy the MAC

address of the Ethernet Card installed by your ISP and

replace the WAN MAC address with the MAC address of the

router. It is not recommended that you change the default

MAC address unless required by your ISP.

Enter the DNS (Domain Name Server) server IP address

assigned by your ISP.

Host

Name:

MAC Address:

Internet Setup

Dynamic

Clone MAC

Address:

Primary /

Secondary

DNS

Addresses:

MTU:

Maximum Transmission Unit - You may need to change the MTU for optimal performance with your specic ISP.

Access

Point

Mode:

Checking this box disables NAT and turns the Router into

an Access Point only.

To manually set up the Internet connection, click the Manual Internet Connection Setup button on the Router’s

opening window.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 107 108

No comments

D-Link DAP-1150 User Manual Page 54