D-Link DAP-1150 User Manual download pdf (Page 55)

55D-Link DAP-1150 User Manual

Section 3 - Conguration

Select Dynamic (most common) or Static. Select Static if your

ISP assigned you the IP address, subnet mask, gateway, and

DNS server addresses.

Enter your PPPoE user name.

Enter your PPPoE password and then retype the password in

the next box.

Enter the ISP Service Name (optional).

Enter the IP address (Static PPPoE only).

Enter the Primary and Secondary DNS Server Addresses (Static

PPPoE only).

Enter a maximum idle time during which the Internet connection

is maintained during inactivity. To disable this feature,

enable Auto-reconnect.

Maximum Transmission Unit - You may need to change the

MTU for optimal performance with your specic ISP. 1492 is

the default MTU.

Select either Always-on, Manual, or Connect-on demand.

PPPoE:

User Name:

Password:

Service Name:

IP Address:

DNS

Addresses:

Maximum Idle

Time:

MTU:

Connection

Mode Select:

Internet Setup

PPPoE

Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide

you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE

software from your computer. The software is no longer needed and will not work through a router.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 107 108

No comments

D-Link DAP-1150 User Manual Page 55