D-Link DAP-1360 User Manual download pdf (Page 75)

75D-Link DAP-1360 User Manual

Section 4 - Security

Conﬁgure WEP

It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please

establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption

due to the added overhead.

1. Log into the web-based conguration by opening a web

browser and entering the IP address of the access point

(192.168.0.50). Click on Setup and then click Wireless

Settings on the left side.

2. Next to Security Mode in the Wireless Security Mode

section, select Enable WEP Wireless Security (Basic).

3. Next to Authentication, select Open or Shared Key.

4. Next to WEP Encryption, select 64-bit or 128-bit encryption.

5. Next to Key Type, select either Hex or ASCII.

Hex (recommended) - Letters A-F and numbers 0-9 are valid.

ASCII - All numbers and letters are valid.

6. Next to Key 1, enter a WEP key that you create. Make sure

you enter this key exactly on all your wireless devices. You

may enter up to 4 different keys.

7. Click Save Settings at the top of the window to save your settings. If you are conguring the access point with a

wireless adapter, you will lose connectivity until you enable WEP on your adapter and enter the same WEP key as

you did on the access point.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 97 98

No comments

D-Link DAP-1360 User Manual Page 75