To configure the 802.1Q Port VLAN_ID:
Figure 74. config pvid command
Port Mirroring Commands
The port mirroring commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config mirror port
[enable | disable] {<port> source
ports <portlist> [rx | tx |both]}
show mirror
show mirror
Each command is listed, in detail, in the following sections.
config mirror port
Purpose
Used to configure a mirror port – source port pair
on the Switch. Traffic for any source port to a
77
Comments to this Manuals