D-Link DES-2108 User's Guide download pdf (Page 84)

target port can be mirrored for real-time analysis.

Syntax [enable | disable] {<port> source ports

<portlist> [rx | tx |both]}

Description

This command allows you configure a mirror port

- source port pair on the Switch.

Description <port> - This specifies the Target port (the port

where mirrored packets will be received). The

target port must be configured in the same VLAN

and must be operating at the same speed as the

source port. If the target port is operating at a

lower speed, the source port will be forced to

drop its operating speed to match that the target

port.

source ports - The port or ports being mirrored.

This can not include the Target port.

config mirror port

Description <portlist> - This specifics a port or range of

ports that will be mirrored. That is the range of

ports which all traffic will be copied and sent to

the Target port.

rx - Allows the mirroring of only packets received

by (flowing into) the port or ports in the port list.

tx - Allows the mirroring of only packets sent to

(flowing out of) the port or ports in the port list.

both - Mirrors all the packets received or sent by

the port in the port list.

Example usage:

To enable and configure the Port Mirror function of the Switch:

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 121 122

No comments

D-Link DES-2108 User's Guide Page 84