Command Parameters
enable stp
disable stp
config stp
{maxage <value 6-40> | hellotime
<value 1-10> | forwarddelay <4-30>
| priority <value 1-65535> | fbpdu
[enable | disable]}
config stp ports
[all | <portlist>] {cost <value 1-
65535> | priority <value 0-255>}
show stp
show stp ports
<portlist>
Each command is listed, in detail, in the following sections.
enable stp
Purpose
Used to enable STP on the Switch.
Syntax enable stp
Description
This command allows the Spanning Tree
Protocol to be enabled on the Switch.
Parameters
None.
Example usage:
To enable STP on the Switch:
Figure 82. enable stp command
86
Comments to this Manuals