D-Link DSA-3200 Technical Information Page 208

  • Download
  • Add to my manuals
  • Print
  • Page
    / 321
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 207
xStack
®
DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide
194
NOTE: See Appendix A for more information on how to prevent ARP Spoofing
attacks.
BPDU Attack Protection
This window is used to configure the BPDU protection function for the ports on the switch. In generally, there are two states in
BPDU protection function. One is normal state, and another is under attack state. The under attack state have three modes: drop,
block, and shutdown. A BPDU protection enabled port will enter an under attack state when it receives one STP BPDU packet.
And it will take action based on the configuration. Thus, BPDU protection can only be enabled on the STP-disabled port.
BPDU protection has a higher priority than the FBPDU setting configured by configure STP command in the determination of
BPDU handling. That is, when FBPDU is configured to forward STP BPDU but BPDU protection is enabled, then the port will
not forward STP BPDU.
BPDU protection also has a higher priority than the BPDU tunnel port setting in determination of BPDU handling. That is, when a
port is configured as BPDU tunnel port for STP, it will forward STP BPDU. But if the port is BPDU protection enabled. Then the
port will not forward STP BPDU.
To view the following window, click Security > BPDU Attack Protection:
Figure 6 - 78. BPDU Attack Protection window
The following parameters can be configured:
Parameter Description
BPDU Attack
Protection State
Click the radio buttons to enable or disable the BPDU Attack Protection state.
Trap State
Specify when a trap will be sent. Options to choose from are None, Attack Detected, Attack
Cleared or Both.
Page view 207
1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 320 321

Comments to this Manuals

No comments