D-Link DSA-3200 Technical Information download pdf (Page 257)

xStack

DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide

243

MAC - The MAC address of the Switch will be used to encode the circuit ID option.

IP - The Switch’s IP address will be used to encode the circuit ID option. This is the default.

UDF - A user specified string to be used to encode the circuit ID option. The maximum length

is 32.

Click the Apply button to accept the changes made for each individual section.

SMTP Settings

SMTP or Simple Mail Transfer Protocol is a function of the Switch that will send switch events to mail recipients based on e-mail

addresses entered in the window below. The Switch is to be configured as a client of SMTP while the server is a remote device

that will receive messages from the Switch, place the appropriate information into an e-mail and deliver it to recipients configured

on the Switch. This can benefit the Switch administrator by simplifying the management of small workgroups or wiring closets,

increasing the speed of handling emergency Switch events, and enhancing security by recording questionable events occurring on

the Switch.

Users can set up the SMTP server for the Switch, along with setting e-mail addresses to which switch log files can be sent when a

problem arises on the Switch.

To view the following window, click Network Application > SMTP Settings:

Figure 8 - 22. SMTP Settings window

The following parameters may be configured or viewed:

Parameter Description

SMTP State

Use the radio button to enable or disable the SMTP service on this device.

SMTP Server

Address

Enter the IP address of the SMTP server on a remote device. This will be the device that sends

out the mail for you.

SMTP Server Port

(1-65535)

Enter the virtual port number that the Switch will connect with on the SMTP server. The common

port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.

Self Mail Address

Enter the e-mail address from which mail messages will be sent. This address will be the “from”

address on the e-mail message sent to a recipient. Only one self-mail address can be configured

for this Switch. This string can be no more that 64 alphanumeric characters.

Add A Mail

Receiver

Enter an e-mail address and click the Add button. Up to eight e-mail addresses can be added

per Switch. To delete these addresses from the Switch, click the corresponding Delete button in

the SMTP Mail Receiver Address table at the bottom of the window.

Click Apply to implement the changes.

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 320 321

No comments

D-Link DSA-3200 Technical Information Page 257