D-Link DSA-3200 Technical Information download pdf (Page 49)

xStack

DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide

Figure 2 - 43. SNMP Engine ID window

The following parameter can be configured:

Parameter Description

Engine ID

The SNMP engine ID displays the identification of the SNMP engine on the Switch. The

default value is suggested in RFC2271. The very first bit is 1, and the first four octets are set

to the binary equivalent of the agent’s SNMP management private enterprise number as

assigned by IANA (D-Link is 171). The fifth octet is 03 to indicate the rest is the MAC

address of this device. The sixth to eleventh octets is the MAC address.

Click Apply to implement the changes.

SNMP Trap Configuration

Users can enable and disable global SNMP trap support, SNMP authentication failure trap support, Linkchange Traps, Coldstart

Traps, and Warmstart Traps. To enable Linkchange Traps for a specific port or range of ports, go to the SNMP Linkchange Traps

Settings window.

To view the following window, click Configuration > SNMP Settings > SNMP Trap Configuration:

Figure 2 - 44. SNMP Trap Configuration window

To enable or disable the SNMP Traps, SNMP Authenticate Traps, Linkchange Traps, Coldstart Traps, and Warmstart Traps, use

the corresponding drop-down menu to change and click Apply.

RMON

Users can enable and disable remote monitoring (RMON) status for the SNMP function on the Switch. In addition, RMON Rising

and Falling Alarm Traps can be enabled and disabled.

To view the following window, click Configuration > SNMP Settings > RMON:

Figure 2 - 45. RMON window

To enable or disable RMON for SNMP, use the radio buttons. Click Apply when finished.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 320 321

No comments

D-Link DSA-3200 Technical Information Page 49