D-Link DES-3226L Technical Information download pdf (Page 95)

Access and Security Commands 95

User This field lists every user that has an authentication login list assigned.

System Login This field displays the authentication login list assigned to the user for sys-

tem login.

802.1x Port Security This field displays the authentication login list assigned to the user

for 802.1x port security.

RADIUS Commands

This section describes the commands you use to configure the D-Link DES-3226L switch to use a

Remote Authentication Dial In User Service (RADIUS) server on your network for authentication and

accounting.

radius accounting mode

This command is used to enable the RADIUS accounting function.

Default disabled

Format radius accounting mode

Mode Global Config

no radius accounting mode

This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS

accounting function is disabled.

Format no radius accounting mode

Mode Global Config

radius server host

This command is used to configure the RADIUS authentication and accounting server. If you use the

<auth> parameter, the command configures the IP address to use to connect to a RADIUS

authentication server. You can configure up to 3 servers per RADIUS client. If the maximum number of

configured servers is reached, the command fails until you remove one of the servers by issuing the

“no” form of the command. If you use the optional <port> parameter, the command configures the UDP

port number to use when connecting to the configured RADIUS server. The <port> number range is 1 -

65535, with 1812 being the default value.

Note: To re-configure a RADIUS authentication server to use the default UDP <port>, set

the <port> parameter to 1812.

If you use the <acct> token, the command configures the IP address to use for the RADIUS accounting

server. You can only configure one accounting server. If an accounting server is currently configured,

use the “no” form of the command to remove it from the configuration. The IP address you specify must

match that of a previously configured accounting server. If you use the optional <port> parameter, the

command configures the UDP port to use when connecting to the RADIUS accounting server. If a

<port> is already configured for the accounting server, the new <port> replaces the previously

configured <port>. The <port> must be a value in the range 1 - 65535, with 1813 being the default.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 127 128

No comments

D-Link DES-3226L Technical Information Page 95