D-Link DVG-3016S User Manual download pdf (Page 28)

pause for 1 second before dialing the destination number. Each comma represents a 1 second

delay. If more delay time is required, simply add more commas. Please note that if a Dial-out

prefix is set, the line won’t be able to dial to any PBX extension line (FXS interface does not have a

trunk prefix function). Please refer to Section 6 if required to dial to a PBX extension line and

PSTN concurrently.

 Enable FAX: Enable this line to detect if there is a FAX tone to transfer the Codec.

 Trunk Hunting Order: To set FXO dial-out mode when there is an incoming call dialed

FXO representative number.

First Idle: The gateway will assign each unassigned call from first FXO line.

Sequential: The gateway will automatically assign the first unassigned call to the first

FXO line. The second FXO line will dial the second unassigned call out. Each line will be

used.

 Enable FXO/Trunk Extension Number: Select this function only when FXO receives 2 or

more different PBX or PSTN, or under special circumstances. Users are free to call out

from a desired channel, if assigned. If you register to a Proxy it MUST be checked.

Description:

If the remote party wants to assigns Line DVG-3016S to make a call, he/she can dial port number

and destination number. For example 706

22520199.

If this item isn’t checked, the gateway will select a line automatically to call out from. For example,

dial 22520199 without adding the extension number of the FXO port.

 Pick up Line by Dialing Extension Number: Allows user to dial just the FXO extension –

717 - to use when the PSTN line is connected on the FXO port. If you are registered to a

Proxy, it MUST be checked.

 Wait for Caller ID before FXO / Trunk pick up: To detect caller ID from FXO port.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

No comments

D-Link DVG-3016S User Manual Page 28