D-Link DSL 2750U User Manual download pdf (Page 24)

DSL-2750U 3G/ADSL/Ethernet Router with Wi-Fi

and Built-in Switch

User Manual

Installation and Connection

PC with Wi-Fi Adapter

1. To connect via 3G network: connect your USB modem to the USB port

located on the back

panel of the router.

If you need to connect or change a USB modem to another one when the router is powered

on, power off the device, connect the modem to the USB port, and power on the router.

2. To connect the router to a DSL line: connect a phone cable between the DSL port of the

router and the ADSL OUT port of the splitter. Connect your phone to the PHONE port of

the splitter. Then connect another phone cable between a phone jack and the ADSL IN port

of the splitter.

3. To connect the router to an Ethernet line: connect the Ethernet cable between any of four

Ethernet ports located on the back panel of the router and the Ethernet line.

4. Connect the power cord to the power connector port on the back panel of the router, then

plug the power adapter into an electrical outlet or power strip.

5. Turn on the router by pressing the ON/OFF button on its back panel.

6. Turn on Wi-Fi by pressing the relevant button on the back panel of the router.

7. Turn on your PC and wait until your operating system is completely loaded.

8. Turn on your Wi-Fi adapter. As a rule, modern notebooks with built-in wireless NICs are

equipped with a button or switch that turns on/off the wireless adapter (refer to your PC

documents). If your PC is equipped with a pluggable wireless NIC, install the software

provided with your Wi-Fi adapter.

7 It is recommended to use a USB extension cable to connect a USB modem to the router.

Page 24 of 138

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 137 138

No comments

D-Link DSL 2750U User Manual Page 24